Cold Flow Improver For Middle Distillates

Cold Flow Improver For Middle Distillates

Cold flow improver for middle distillates ZX-P2-04 contains highly efficient anticoagulant factors, which can effectively lower the freezing point of diesel and prevent it from solidifying at low temperatures.
Send Inquiry
Description
General

 

Cold flow improver for middle distillates ZX-P2-04 contains highly efficient anticoagulant factors, which can effectively lower the freezing point of diesel and prevent it from solidifying at low temperatures. It can usually lower the freezing point of diesel by 10℃to 20℃. In extremely cold weather, Cold flow improver and pour point depressant for middle distillates CAN ensure DIESEL remains liquid, prevent clogging of key components such as pipes, filters and injectors, KEEP fuel system running smoothly. By refining the wax crystals, the pour point depressant can effectively prevent diesel from waxing at low temperatures and further improve the low-temperature fluidity of the oil product. ‌

Flow improver and pour point depressant for middle distillates ZX-P2-03 is refined from highly efficient anticoagulant factors, co-solvents, etc. It can quickly mix with diesel, control the formation of paraffin crystals when cooled, significantly reduce the cold filter point and pour point of diesel, further improve the low-temperature fluidity of the oil, and effectively solve the problems caused by sudden temperature drops, cross-regional travel, and low-temperature driving

 

Composition

 

Ethylene based copolymer

 

Product properties

 

Appearance

Colorless wax

Density at 20℃

ca. 940 g/cm³

Viscosity at 70℃

ca. 1300 m㎡/s

Viscosity at 120℃

ca. 300 m㎡/s

Pour point

ca. 50 ℃

Flash point

≥ 100 ℃

Solubility

Cold flow improver for middle distillates ZX-P2-04 is free of solvents.

Cold flow improver for middle distillates ZX-P2-04 is soluble in aliphatic solvents in all proportions, but insoluble in water and polar organic liquids.

 

The above listed data represent average values at the time of going to press of this technical information. They are intended as a guide to facilitate handling and cannot be regarded as specified data.. Specified product data are issued as a separate product specification.

 

Application

 

Performance and Application

Cold flow improver for middle distillates ZX-P2-04 considerably improves the flow properties of middle distillates at low temperature. Cold flow improver for middle distillates ZX-P2-04 acts as a crystallization modifier for higher n-paraffins. It prevents the formation of a coherent network for paraffin wax crystals with the result that the cold properties of the middle distillate are considerably improved.

Cold flow improver for middle distillates ZX-P2-04 is a solvent-free high molecular wax, it is strongly recommended to dilute the product prior its use. Suitable solvents for preparing Cold flow improver for middle distillates ZX-P2-04 solutions are middle distillates and aromatic hydrocarbons "solvent naptha". Typically, the degree of dilution should be 40-60%. Technical recommendations on the dilution process can be made available.

Cold flow improver for middle distillates ZX-P2-04 is added to the middle distillates at addition rates of 25 - 1000 ppm. Besides the degree of dilution, the actual injection rate depends on the composition of the middle distillate and is characterized by the cloud point, the boiling range, the type and the amount of paraffins, and other parameters.

Lines through which undiluted Cold flow improver for middle distillates ZX-P2-04

is pumped should be heated to 60-80℃. Cold flow improver for middle distillates ZX-P2-04 should be pumped with temperature of around 30-40℃.

The diluted Cold flow improver for middle distillates ZX-P2-04 is injected directly into the stream of a middle distillate. For the injection of the additive a temperature of 30-40℃is most favorable. The temperature of the middle distillates to be dropped should be about 30-45℃. A mixing section of adequate length in the pipelines is required.

 

Storage and handling

Cold flow improver for middle distillates ZX-P2-04 can be stored at least for 1 year. The storage temperature should not exceed 80 ℃. Short-term exposure to temperature up to 120℃ will not affect the performance of the product. During storage, the liquid wax should be covered by a nitrogen blanket.

 

Packaging

in bulk or in barrel, per clients' request

 

Safety

When using this product, the information and advice given in our safety data sheet should be observed. Due attention should also be given to the precautions necessary for handling chemicals.

 

Note

The data contained in this publication are based on our current knowledge and experience. In view of the many factors that may affect processing and application of our product, these data do not relieve processes from carrying out their own investigations and tests; neither do these data imply any guarantee of certain properties, not the solubility of the product for a specific purpose. Any descriptions, drawings, photographs, data, proportions, weights etc. given herein may change with prior information and do not constitute the agreed contractual quality of the product. It is the responsibility of the recipient of our products to ensure that any proprietary rights and existing laws and legislation are observed.

Hot Tags: cold flow improver for middle distillates, China cold flow improver for middle distillates manufacturers, suppliers, factory, ddp paperwork, cfi export license, ddp warehousing, cfi price, cfi shipping terms, ddp duty paid